H3c-technologies H3C SecPath F5000-A5 Firewall User Manual download pdf (Page 51)

41

Memory Size : 4096MB

Memory Speed : 533MHz

BootWare Size : 1536KB

Flash Size : 4MB

cfa0 Size : 247MB

CPLD Version : 3.0

PCB Version : Ver.B

BootWare Validating...

Press Ctrl+B to enter extended boot menu...

Starting to get the main application file--cfa0:/main.bin!....

............................................................................

............

The main application file is self-decompressing.............................

...

Press ENTER to get started.

Press Enter at the prompt. When the prompt <H3C> appears, you can configure and manage the

firewall.

NOTE:

• To access the extended Boot menu (also called the "main BootWare menu"), press Ctrl+B immediately

after "Press Ctrl+B to enter extended boot menu" is displayed. If you fail to press Ctrl+B timely, the

device automatically starts up. You must reboot the firewall if you still want to access the extended Boo

menu.

• The boot information depends on the software version.

Logging in to the CLI by using Telnet

This section provides only a simplified procedure for logging in to the CLI by using Telnet. For more

information, see the firewall configuration guides.

To log in to the CLI by using Telnet:

1. Log in to the firewall through the console port, execute the telnet server enable command in system

view to enable the Telnet service, and execute the user privilege level command in VTY user

interface view to specify the command level for Telnet users. By default, the Telnet service is

disabled on the firewall.

2. Connect a PC to the firewall's management interface M-GigabitEthernet 0/0 by using a crossover

Ethernet cable.

3. Assign the PC an IP address in the network segment 192.168.0.0/24 (except for 192.168.0.1),

for example, 192.168.0.2.

4. Run the Telnet client on the PC to Telnet to the firewall.

H3c-technologies H3C SecPath F5000-A5 Firewall User Manual Page 51