H3c-technologies H3C S12500X-AF Series Switches User Manual download pdf (Page 39)

Figure 34 Installing a fan tray for the S12504X-AF switch

(1)

n the positionin

pin on the fan tray with the positionin

hole in the chassis

(2) Insert the fan tray into the chassis

(3) Fasten the

captive screws on the fan tray

Installing power modules

The power module slots are located at the two sides of the rear panel.

To install a power module:

1. Thread the flat-blade screwdriver through the hole in the handle of the filler panel and pull the

filler panel out. See Figure 35.

2. Corr

ectly orient the power module.

If you install the power module in a left power module slot, make sure the latch is above the

handle. If you install the power module in a right power module slot, make sure the latch is below

the handle.

3. Holding the handle of the power module with one hand and supporting the bottom of the power

module with the other, slide the power module along the guide rails into the slot until you hear a

click.

The power module is foolproof. If the power module is oriented incorrectly, you cannot install the

power module into the slot. If you encounter a hard resistance while inserting the power module,

pull out the power module, reorient it, and then insert it again.

1 2 ... 34 35 36 37 38 39 40 41 42 43 44 ... 52 53

No comments

H3c-technologies H3C S12500X-AF Series Switches User Manual Page 39