H3c-technologies H3C S5120 Series Switches User Manual download pdf (Page 45)

CAUTION:

Pay attention to the mark on the console port and be sure to plug the connector to the correct port.

NOTE:

• When connecting a PC to a powered-on switch, H3C recommends you to connect the DB-9 connector

of the console cable to the PC before connecting the RJ-45 connector to the switch.

• When disconnecting a PC from a powered-on switch, H3C recommends you to disconnect the DB-9

connector of the console cable from the PC after disconnecting the RJ-45 connector from the switch.

Setting terminal parameters

When setting up the configuration environment through the console port, the terminal or PC can use the

terminal emulation program to communicate with the switch. You can run the HyperTerminal of the

Windows operating system to connect to other PCs, network devices, and Telnet sites. For detailed

information and the use of the HyperTerminal, see the HyperTerminal Help documentation in Help and

Support Center on the PC running the Windows operating system.

In the following configuration procedure, Windows XP HyperTerminal is used to communicate with the

switch.

1. Start the PC and run the terminal emulation program.

2. Set terminal parameters as follows:

• Bits per second: 9,600

• Data bits: 8

• Parity: None

• Stop bits: 1

• Flow control: None

• Emulation: VT100

The specific procedure is as follows:

Step1 Select Start > All Programs > Accessories > Communications > HyperTerminal to enter the

HyperTerminal window. The Connection Description dialog box appears, as shown below.

1 2 ... 40 41 42 43 44 45 46 47 48 49 50 ... 73 74

No comments

H3c-technologies H3C S5120 Series Switches User Manual Page 45